SAF OPAL Ethernet IP Interface MS6 SERIES Manuel d'utilisateur télécharger pdf (Page 6)

Opal Pro to Mod TCP

Page 6

Opal Pro to Mod TCP

Introduction

The Opal Pro can be monitored and controlled over an Ethernet

communication network using the AB Ethernet IP protocol. The Opal Pro

connects to the Ethernet network through and optional Ethernet card that

is mounted on the main Opal Pro control card (CA530). Access is gained

to the Ethernet card via the communication opening on the right side of

the Opal Pro. The Opal Pro is a AB Ethernet IP slave and is mapped as

I/O through an Ethernet bridge

Hardware

Connection is made via a 10Mbaud Ethernet port which utilizes a RJ45

connector. Connection should be made using CAT 5 cable.

Jumper Settings

Jumper Setting Description

J3 Not installed Boot Block write enable

J4 Installed on

pins 1 and 2

Disable test mode

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

SAF OPAL Ethernet IP Interface MS6 SERIES Manuel d'utilisateur Page 6